GB - 14
Cutting Height Range
The rear wheels have two cutting height
ranges.
To change the range, support the rear of the
unit and then remove the rear wheels.
Remove the mounting hardware from the
cutting height adjuster and then turn the
adjuster forward or rearward to raise or lower
the cutting height range. Replace the
mounting hardware and reinstall the rear
wheel. See Figure 11.
NOTE: Finger tighten the mounting
hardware, install the rear wheel, and then
tighten the mounting hardware the rest of the
way. The adjuster should move forward and
rearward without binding.
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
Wheel Drive Control
NOTE: Engine must be running for wheel
drive to propel unit.
To drive forward:
Slowly pull the wheel drive control toward
you until you reach a comfortable ground
speed. Hold the wheel drive control in this
position to maintain the speed.
To stop:
Release wheel drive control.
Fuel Shutoff Valve
IMPORTANT: The fuel shutoff valve MUST
be in the closed position prior to transporting
the unit.
Open the fuel shutoff valve to operate the
unit. Close the fuel shutoff valve when
storing, transporting or servicing the unit.
911250, 254
Fuel shutoff valve
open.
Fuel shutoff valve
closed.
Figure 11
Install mounting
hardware here for
shorter cutting
height.
Install mounting
hardware here for
taller cutting height.
Install rear wheel
here for taller
cutting height.
Mounting
Hardware
Install rear wheel
here for shorter
cutting height.
CAUTION: Unit will move forward
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
Figure 12
