GB - 13
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
Wheel Drive Control
(self-propelled models) (911152, 156)
NOTE: Engine must be running for wheel
drive to propel unit.
To drive forward:
Slowly squeeze the wheel drive control
toward the handlebar until you reach a
comfortable ground speed. Hold the wheel
drive control against the handlebar for full
speed.
To stop:
Release wheel drive control.
Speed Limiter (911152, 156)
The speed limiter increases or decreases
tension in the drive cable, which limits the
unit’s forward speed.
In the operator’s position, turn the speed
limiter to the left to increase maximum
forward speed. Turn the speed limiter to the
right to decrease maximum forward speed.
Ignition Switch (911156)
A removable key operates
the ignition switch. Turn the
key to the start position (2)
to start the unit. The key
will spring back to the
“RUN” position.
RUN Position (1): All
controls are operable.
START Position (2):
Starter turns over the
engine.
FILLING THE FUEL TANK
To add fuel to fuel tank:
1. Put unit in open or well-ventilated area.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area.
4. Remove cap.
IMPORTANT: See engine manual for correct
type and grade of fuel.
5. Fill fuel tank to within 1/4 in. (0.63 cm)
below bottom of filler neck with unleaded
gasoline. See SPECIFICATIONS on
page 25.
6. Replace fuel cap and tighten.
7. ALWAYS clean any spilled fuel.
CAUTION: Unit will move forward
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
STOP
GO
OM1245
GO
Figure 8
Figure 9
1
2
