GB - 7
DO NOT touch unit parts which might be hot
from operation. Allow parts to cool before
attempting to maintain, adjust or service.
ALWAYS stop unit and allow moving parts to
stop before leaving operator zone. Do not
leave running unit unattended.
DO NOT operate in the rain or in wet or damp
locations. Assure that operator zone is free or
debris and provides good footing.
Know the weight of logs. Limit logs to those
you can safely control and the unit can safely
handle.
Do not use log splitter for any purpose other
than splitting logs.
Do not move the unit up or down a hill by
hand. Use a tow vehicle with suitable braking
system.
Use extra care when towing unit. DO NOT
exceed 45 mph (72.4 kph).
Safety chains MUST be attached to vehicle
when towing unit.
NEVER allow anyone to ride on the unit.
NEVER transport cargo on the log splitter
Check local, state and federal laws before
towing. Any modifications required to meet
these laws are the responsibility of the
purchaser.
ALWAYS stop engine, lock beam in horizontal
position and close fuel shut-off valve when
transporting unit.
Keep unit free of leaves and other debris. DO
NOT spray water to clean unit.
ALWAYS keep protective structures, guards,
and panels in good repair, in place and
securely fastened. NEVER modify or remove
safety devices.
Stop and inspect equipment if there is an
unusual vibration. Repair, if necessary, before
restarting. Never make adjustments or repairs
without first disconnecting the spark plug
wire.
Keep all hardware properly tightened.
Maintain or replace safety and instruction
labels, as necessary.
Use only attachments or accessories
designed for your unit.
Check attachment components frequently. If
worn or damaged, replace with
manufacturer’s recommended parts.
This product is equipped with an internal
combustion engine. DO NOT use on or near
any unimproved, forest covered or brush
covered land unless the exhaust system is
equipped with a spark arrester meeting
applicable local, state or federal laws. A spark
arrester, if used, must be maintained in
effective working order by the operator.
DO NOT run engine in an enclosed area.
Always provide good ventilation. Fumes from
engine exhaust can cause injury or death.
Fuel is highly flammable and its vapors are
explosive. Handle with care. Use only an
approved gasoline container with an
appropriately sized dispensing spout.
No smoking, No sparks, No flames. ALWAYS
allow engine to cool before servicing.
NEVER fill fuel tank when engine is running
or hot from operation.
NEVER fill or drain fuel tank indoors.
Replace fuel cap securely and clean up
spilled fuel.
Properly remove fuel before tipping unit.
Never fill fuel containers inside a vehicle or
on a truck or trailer bed with a plastic liner.
Always place containers on the ground away
from your vehicle before filling.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle lock-
open device.
If fuel is spilled on clothing, change clothing
immediately.
NEVER store fuel inside where there is an
open flame, such as a water heater.
HYDRAULIC FLUID can result in severe
burns
.
Fluid in hydraulic system can
penetrate skin and result in serious injury or
death.
•
Be sure to stop the engine and relieve
hydraulic pressure before doing any
work on hydraulic parts.
•
Keep body and hands away from pin
holes or nozzles which expel hydraulic
fluid when under pressure. Use paper
or cardboard, not hands, to search for
leaks.
•
Ensure all hydraulic fluid connections
are tight and all hydraulic hoses and
lines are in good condition before
applying pressure to system.
•
FOREIGN FLUID INJECTED INTO
BODY can result in gangrene. Fluid
must be surgically removed within a
few hours by a doctor familiar with this
form of injury.
•
Do not adjust the pressure settings on
the hydraulic pump or valve.
