EN - 7
If your log splitter is equipped with an
internal-combustion engine and intended for
use near any unimproved forest, brush, or
grass covered land, the engine exhaust
should be equipped with a spark arrestor.
Make sure you comply with applicable local,
state, and federal codes. Take appropriate
fire-fighting equipment with you.
Log splitters should be used only for splitting
wood. Do not use for other purposes unless
the manufacturer provides attachments and
instructions.
If unit is to be used by someone other than
original purchaser; loaned, rented or sold,
ALWAYS provide this manual and any
needed safety training before operation.
Operation
Before starting this log splitter, review the
"Rules for safe Operation." Failure to follow
these rules may result in serious injury to the
operator or bystanders.
Never leave the machine unattended with
the power source operating.
Never operate the machine when under the
influence of alcohol, drugs, or medication.
The machine owner should instruct all
operators in safe log-splitter operation.
Always operate the log splitter with all safety
equipment in place and all controls properly
adjusted for safe operation.
Always operate the log splitter at
manufacturer's recommended speed.
Always keep hands and feet clear of moving
parts.
When loading a ram-type log splitter, place
your hands on the sides of the log not at the
ends. Never place your hands or any part of
your body between a log and any part of the
log splitter.
On ram-type log splitters, never attempt to
split more than one (1) log at a time unless
the ram has been full extended and a
second log is needed to complete the
separation of the first log.
On ram-type log splitters on which the logs
are not cut square, the longest portion of the
log should be rotated down and the most
square end placed against the ram.
Use only your hand to operate the log
splitter controls.
Do not refuel the engine until it has cooled
for several minutes.
Before starting engine ensure that control
lever is in neutral position.
Operate unit only when there is sufficient
light to clearly see work area.
NEVER allow children to operate or play on
or near unit.
Operate unit only when standing in operator
zone. Unit stabilizers must be extended
before starting unit.
Use wheel chocks to prevent movement of
unit during operation.
ALWAYS keep hands away from all moving
parts during operation. Moving parts can cut
or crush body parts.
DO NOT operate in the rain or in wet or
damp locations. Assure that operator zone is
free or debris and provides good footing.
Know the weight of logs. Limit logs to those
you can safely control and the unit can
safely handle.
Logs should be cut with square ends before
placing on splitter.
Position logs against end plate grips before
operating hydraulic cylinder.
On logs that are not square place the
longest portion of the log closest to the
beam and the most square end against the
splitter wedge.
Do not attempt to stabilize logs with legs or
feet while operating. Moving parts can cut off
or crush body parts.
Split logs end to end in the direction of the
grain, not against the grain.
Keep fingers and hands away from cracks in
logs while splitting. These can quickly close
and pinch or crush body parts.
Maintenance and Storage
Always shut off the power source while
repairing or adjusting the splitter except as
recommended by the manufacturer.
Clean debris and chaff from engine cylinder,
cylinder head fins, blower housing rotating
screen, and muffler areas. If the engine is
equipped with a spark arrester muffler, clean
and inspect it regularly (follow
manufacturer's service instructions).
Replace, if damaged.
