39
Route the shoulder portion of the belt around
the rear of the seat and under the shoulder belt
guide. If vehicle belt latch plate does not lock, then
retractor must be switched. CHECK the vehicle
owner’s manual and page 23 to see how to lock
your seat belt.
Pull on shoulder portion toward the retractor while
pressing down on the center of the carrier to
tighten carrier to vehicle seat.
CHECK to make sure carrier is secure by holding
both sides near the lap belt guides and moving it
from side to side and front and back. The lap belt
should not loosen and the carrier should not move
easily. The carrier should not move more than 1
inch (2.5 cm) from side to side or front to back.
After installing carrier without
base check the RED level
line on the label beneath the
handle to make sure that it is
level with the ground.
If seat is still not level, refer to page 45,
when
using the carrier with WITHOUT the base.
4
5
4
5
4
5
4
5
RED
line
MUST
be level
with the ground when
installed in vehicle
WITHOUT
the base.
RED
line
MUST
be level
with the ground when
installed in vehicle
WITHOUT
the base.