Argus 010-523-B2, User Manual

Page: 27 / 32

5.0 OPERATION
5.1 Startup
Ensure all power and alarm connections are secure and the AC input voltage selection jumpers are
set correctly (see AC Voltage Selection under Installation Instructions for details). Re-install the
back cover and plug the AC cable into the rear of the unit.
The battery fuse(s) should be installed after AC power has been applied to the charger and the
POWER ON LED is illuminated. Although this procedure is not critical it will ensure a more con-
trolled charging of the output filter capacitors, and power up of the control circuitry in the charger.
5.2 Shutdown
Unplug the AC cable from the rear of the unit. Ensure the battery is not connected to the load (the
ON BATTERY LED(s) are off). Remove the battery fuse(s).
010-519-C0 Rev. A Page 13 of 15 ARGUS TECHNOLOGIES