5
Introduction
Installation
RS-232
1)
Disconnect power to the terminal/computer.
2)
Connect the appropriate interface cable and external
power supply (DC adapter) to the scanner.
3)
Plug the serial connector into the serial port on the back
of your computer/terminal. Tighten the two screws to
secure the connector to the port.
4)
Plug the power pack into a power source.
5)
Once the scanner has been fully connected, turn the
terminal/computer power back on.
USB HID (Simulate with keyboard wedge)
1) Connect the USB cable between scanner and PC.
2) Windows will automatically detect the USB device.
USB Com
1) Connect the USB cable between scanner and PC.
2) Windows will automatically detect the USB device.
Note:
If any of the above operations is incorrect, turn off the
power immediately and check any improper
connections. Go through all above steps again.
Summary of Contents for AS-8150
