28
Calibration and Configuration
This section discusses calibration, printing configuration and
resetting the printer to factory defaults.
Performing Calibration and Configuration
1. Turn off the printer power.
2. Press and hold the feed button while turning on the power,
then the printer will execute calibration to let machine
automatically stock length of the label. (Please continuous
to press the feed button when machine executes
calibration.)
3. Please continuous pressing the feed button until the
printing motor is activated, then printer will execute
configuration, and printing the configuration profile. The
profile includes firmware version, ROM checksum, RS232,
thermal transfer /direct thermal settings, hardware
configuration, and font types.
4. After calibration and configuration, at PPLB emulation, the
printer enters character dump mode. To exit from dump
mode, press the feed button again. (If you accidentally
print the label without exiting from dump mode in advance,
you need to turn on the printer again to print normally.)
29
Resetting to Factory Default Settings
1. Turn on the printer and wait for 5 or more seconds.
2. Press the "Feed" button for 10 seconds, and the "Ready"
indicator and "Power" indicator will go off in order.
3. When the two indicators relight, release the feed button.
4. The printer feeds approximately 3 ~5 blank labels, and
then resets to the factory defaults.
Note:
Revise the factory default settings that stored in flash, even
if turn off the power source cannot be eliminated.
