Argox AS-8000 Series, Instruction Manual

Page: 17 / 134

12
Auto Update
When this feature is enabled, an imager and its linked cradle
can automatically ensure they stay in sync with regard to
firmware and/or configuration. This is accomplished by the
linked imager and cradle comparing firmware version number
and configuration file check sum. If either is different, the
cradle will automatically update the imager with its
firmware/configuration.
If the units are linked, any changes made to the cradle’s
configuration through the scan utility software will
automatically be sent to the imager at the completion of the
programming session. By the same token, any changes
made to the linked imager’s configuration will be transmitted
to the cradle at the end of the programming session.
The following options are available for Auto Update:
z
Enable configuration and firmware auto update –
Allows both configuration and firmware updating
(
Default ).
z Enable configuration auto update only – Allows
only configuration updating.
*$%-1BA00%%*
*$%-1BA01%%*