Argosy HV358T, User Manual, Page: 12 / 48

Using the AV Playback Function
8
Activating the Mobile Video HDD for AV Playback
1. Turn on your TV and AV amplifier (receiver), and switch to the correct input channel.
2. Press the Power switch to turn on the unit, and then press ( STANDBY ) button on the
remote control to activate it. The activation takes about 5-7 seconds, and the LED will blink
brightly at the same time.
3. After the LED stops blinking and turns steadily bright, you can use the remote to operate
this unit for playback.
4. After playback, press ( STANDBY ) again to switch back to the standby mode.
5. If you want to move the Mobile Video HDD, turn off this unit by pressing the Power switch
until the orange LED is turned on, and then it will be safe to remove all connections after
both LEDs are off.
y
When using the remote, point the remote towards this unit’s Remote receiver.
y
During the remote operation, the inhibit icon will appear on the screen
when you pressed a button with non-available operation.
y
If the setting of the video output is incorrect, the TV screen will not display normally.
Switch to correct setting by pressing and holding and then press MENU .
Detail View
After activating this unit, all folders and media files will appear on the screen as the figure
shown below. This mode is called “
Detail View ”.
The top level of the disk is called the “ROOT” folder. While there are some
operations reserved at the ROOT level only, it is recommended to categorize your
files in folders rather than to save all of them underneath the root folder.
Folder name
Selected item
Item information
Total items and the
item number