Argosy HV256T, User Manual

Page: 12 / 48

Using the AV Playback Function
Activating This Device for AV Playback
1.
2.
Turn on your TV and AV amplifier (receiver), and switch to the correct input channel.
Connect the power jack to turn on the unit, and then press (STANDBY) button on the
remote control or button on the keypad to activate it. The activation takes about 5-7
seconds, and the LED will blink at the same time.
3.
4.
5.
After the LED stopped blinking and turned steadily bright, you can use the remote control
to operate this unit for playback.
After playback, press the button again to switch back to Standby mode.
If you want to move this device, wait until the standing-by process complete. It’s safe to
unplug the power jack in Standby mode.
• When using the remote control, point the remote control towards this unit’s
remote receiver.
• During the remote control operation, the inhibit icon will appear on the
screen when you pressed a button with non-available operation.
• If the setting of the video output is incorrect, the TV screen will not display
normally. Press the button on the keypad (See page 25 for more detail).
Detail View
After activating this unit, all folders and media files will appear on the screen as the figure
shown below. This mode is called “Detail View”.
Item information
Item number
／
Total items
Folder name
Selected item
The top level of the disk is called the “ROOT” folder. While there are some
operations reserved at the ROOT level only, it is recommended to categorize your
files in folders rather than to save all of them underneath the root folder.
8