y
y
x
x
Assembly Instructions
9
Step
13
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x:x equals
y:y.
Place the small back
and large back down,
onto the unit as shown.
Make sure that the 2
backs are pushed up
tight against each other
and that they meet in the
centre of the divider’s
back edge.
b:
Nail around the
outside edges of the 2
backs.
Note:
Do not nail where
the 2 backs meet and
nails should be spaced
about 150mm apart.
c:
Push the 6 nail
screws through the 6
back holders and tap
them down between the
small back and large
back and into the
back edge of the divider
. .
Keep tapping the nail
screws in until the
back holders dig into
the small and large back.
10
11
J
K
L
10
11
3
K
L
K
L
10
11
L
L
K
+
Note:
These can
also be round
10
11
Note:
If ever you need to take
the backs off to dismantle the
unit, the nail screws can be
taken out using a screwdriver.
K
L
b:
J
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
c:
y
y
x
x
