Assembly Instructions
9
Step
13
Fit the back panels
a:
Square up the unit by
making sure that
measurement
x to x
equals y to y.
b:
Place the small back
. and large back
coloured surface facing
down, onto the unit as
shown.
Make sure that the 2
backs and are
pushed up tight against
each other and that they
meet in the centre of the
long divider’s back
edge.
Nail around the
outside edges of the 2
backs and .
Note:
Do not nail where
the 2 backs meet.
Nails should be spaced
out evenly.
c:
Using 10 screws ,
screw down between the
2 backs and into
the long divider’s
back edge.
Stand the unit up for
the next step.
C
10
11
11
H
10
3
10
11
10
3
11
Warning:
The
unit is heavy.
Lift with care.
y
x
y
y
x
H
10
10
11
11
c:
Note:
Only use 10 screws .
You will need 1 for a later step.
I
b:
C
The measurement from top corner X to bottom corner X must be
equal to the measurement from top corner Y to bottom corner Y
a:
H
3
Impotant:
If you have fitted the long divider on the left side of the
unit the backs will need to go the opposite way around i.e. the
small back on the left side and the large back on the right side.
Left side
Right side
