Parts installed on the frame
Description
Screw Tork Detail
type Nm
1
Front derailleur hanger
Screw (2)
3mm
4Nm
Loctite
2
Rear derailleur hanger
Screw (2)
3mm 4Nm Loctite
3
Bottle cage
Screw (4)
4mm 3Nm Grease
4
Bottom bracket cable guide
Screw
5mm 1.5Nm Grease
IMPORTANT:
The following parts are assembled on the frame. When assembling the bike, you will need to adjust these parts according to their torque
specifications.
NITROGEN PRO 230A: 1. Frame Inspection
2
BEFORE ASSEMBLING YOUR NEW NITROGEN PRO, MAKE SURE THAT YOU HAVE ALL THE FOLLOWING:
1. Brakes and gears cables and housing set
2: Frameset parts checklist (see p.36)
3: Inspect the frame for cosmetic aspect (scratches, bumps, cracks, paint defect, etc.)
4: For reference, check serial number and write it on p.1
5: All the necessary bolts (refer to Frameset Parts, p.3)
6: For optimal shifting performance, use a dropout alignment gauge to make sure that the drive-side dropout is
straight (p.35)
IMPORTANT: No more than 30mm of spacer can be place between the stem and the top cap of the 3D system.
And the use of more than 5mm spacer on top of the stem could void the efficiency of the compressor.
These practices will automatically cancel any warranty claim against the manufacturer.
