© ARGO S.A.
Nasza oferta w internecie: www.argo.pl
location and FUnction oF control
TEMP.
Press the appropriate key to raise or lower
the temperature per requirement.
the setting range is 0-160 °C (32~320°F)
in 1 degree °C(°F) steps.
SPEED
Press the appropriate key to increase or
decrease the speed per requirement. the
setting range is 1-6 steps.
HOT
Use for Hot laminating. When pressed, temp 100 °C & Speed 4 is set automatically.
COLD
Use for Cold laminating. When pressed, temp & Speed 0 is set automatically.
SB
(Stand By)
this function can be selected during intervals of long time operation. temp 80 °C and
speed 2 is set automatically.
MEAS
this function shows present temperature. the measured is displayed for 3 seconds.
STOP
this can be selected to stop revolution of the rollers.
to protect the rollers, please avoid manually stopping the rollers for a long period of time
when the temperature of the rollers is above 90 °C
REV.
this can be selected to reverse the revolution of the rollers.
in Correct of miss-feed and cleaning of the rollers can be done since the revolution is
reversed while this key is pressed.
°C/°F
Change °C to °F and vice versa.
How to memory
1. Press and Hold [mEm.] button until Beep sounds.
2. Press [mEm.] Button again mEmORY 1 2 3 One of 1, 2, 3 will blink.
3. Select designated temp and Speed using the [UP] and [DOWN] button.
4. After setting the proper temp and Speed, press [mEm.] to move next memory.
5. Press [REV.] button to complete memory insert.
6. to install different setting, start from step 2.
7. Press [COLD] to stop memory.
8. Press [mEm.] button to select proper memory slot.
English
9
