Argo PLATINUM 21 Operating Instructions Manual Download Page 5

 

16

V 10/16 

2.  Check the position of the float inside the tank; it may have shifted during the move.  If it is not positioned 

correctly, reposition it before using it. 

 

 

 
 
 
 

3.  Then, reposition the tank. 

 

OPERATING INSTRUCTIONS 

 

APPLIANCE START-UP 

Place the product on a flat and stable heat-resistant surface, at least 1 metre away from flammable or heat-sensitive 
materials and 50 cm away from walls or other obstructions. 
Make sure the water tank is in the correct position.  
Connect the power cord to a suitable electric socket (220-240V/50Hz).  
Power the unit on with the ON/OFF button on the control panel. 

The dehumidifier is designed to operate at room temperature 

from + 5 °C to + 35 °C

If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.  
When this happens, the dehumidifier goes into defrost mode. The compressor stops, but the fan continues running. 

We recommend not using the dehumidifier in room temperatures lower than 5 °C. 

 

OPERATING PRECAUTIONS

 

The appliance will only start operating if the humidity level in the room is above the set value. 

The dehumidifier will continue to operate until the set humidity level has been reached, 

with the

 

exception of 

interruptions caused by a full tank.

 In this case, empty and reinstall the tank: the dehumidifier will now start running 

again. 

 
WARNING: 
After each interruption of its operation, at least 3 minutes must pass before the dehumidifier starts up again: 
this delay prevents the compressor being damaged.   
If, on the other hand, the set humidity percentage is higher than the level currently found in the room, the 
dehumidifier will not start. 

If, after following the start-up instructions, 

the dehumidifier does not start 

or stops for no reason, make sure the plug 

and power cord are in good working order. After doing so, wait for 10 minutes and then restart the appliance. 
If the dehumidifier still does not start after 10 minutes, or if either the power cord or plug are damaged, switch off the 
appliance and contact an after-sales service centre. 

 
WARNING: 
When the dehumidifier is running, the compressor produces heat and the appliance emits warm air into the 
room. The room temperature will therefore tend to increase. This is completely normal. 
 

TURNING THE DEHUMIDIFIER OFF

 

To turn the dehumidifier off, press the ON/OFF button. This shuts off power to the unit. 
Unplug the appliance if you do not intend to use it for some time. 

 
 
 

Float 

Incorrect 

position 

Correct 
position 

Summary of Contents for PLATINUM 21












Reviews: