14
EN
© arGO s.a.
www.argo.pl
serViCe
Proceed only with routine actions according to the manual. Do not repair or service
machines on your own. Unplug the machine from the circuit and contact seller when one
or more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PrOBlem sOlViNG
problems
checklists
solutions
No operation
The power plug is properly
inserted to main supply?
Fully put the power plug to the
outlet.
switch is set at „i” position?
set switch to „i” position for
operation.
switch at „l” position but power
light off.
check basket is out of stand.Put
basket back to stand.
Basket at stand but power light
off.
Basket should be put into
stand to trigger the safety
interlock switch for operation.
No operation when insert paper? Paper should be inserted to
trigger the sensor at center.
checked above but no operation
and no power light.
send back to your local service
for repair.
No operation after
long time operation
Power lamp is on?
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
stop at shredding
Machine is continuously
shredding for a long time?
Unplug the machine from
main supply. allow to cool
down to room temperature
and resuming operation.
excess squeaking
and rubbing noise
Without oiling to the cutting
system periodically.
- squeaking and rubbing noise at
shredding.
Perform the cutter oiling
instruction to lubricate the
cutting system.
Paper jam
- exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
set switch to „r” for reverse
running and frees excess
paper. Then set to „i” for cutting
the remainder of paper left in
the cutting system. if serious
jim occurred, send back to
local service for repair.
