V 11/21
63
Introduction to the remote control buttons
Preliminary operations
When using the infrared remote control for the first time or after replacing the batteries, set the system time to the current
time by following the steps below.
(1)
By pressing the CLOCK button, the icon
flashes.
(2)
By pressing
or
, the clock time increases or decreases rapidly.
(3)
Press the CLOCK button again to confirm the time and return to the current time display.
Introduction to operation
ON/OFF BUTTON
Press this button to select your required operation mode.
After connecting the power supply, the indoor unit will emit a beep, the icon
will light up.
With the unit on, by pressing the ON / OFF button on the remote control, the icon
will flash on the remote control
display, and the indoor unit will emit a sound to indicate that the signal has been sent from the remote control. You can
then use the remote control to set the various functions.
For models with built-in WiFi or wired controlled, the indoor unit must have been controlled by a standard remote controller
in automatic mode before, so that the temperature regulation function in automatic mode can be used via APP or remote
control. wire.
MODE BUTTON
Operation mode selection. With the unit on, press the MODE button to select the operating mode in the following sequence:
AUTO -> COOL (cooling) -> DRY (dehumidification) -> FAN (ventilation) -> HEAT (heating)
By selecting the Auto mode, the air conditioner operates according to the factory settings. Press the FAN button to adjust
the fan speed. Press the flap swing keys to adjust the swing angle.
By selecting the Cool mode, the air conditioner works in Cooling mode: press the buttons
to set the temperature.
Press the FAN button to adjust the fan speed. Press the flap swing keys to adjust the swing angle.
By selecting the Dry mode, the air conditioner operates in Dehumidification, at low fan speed: the temperature cannot be
adjusted.
Press the flap swing keys to adjust the swing angle.
By selecting the FAN mode, the air conditioner operates in Ventilation only: Press the FAN button to adjust the ventilation
speed. Press the flap swing keys to adjust the swing angle.
By selecting HEAT mode, the air conditioner operates in Heating mode: press the buttons
to set the temperature.
Press the FAN button to adjust the fan speed. Press the flap swing keys to adjust the swing angle.
NOTE:
To prevent the introduction of cold air into the environment, after the start of Heating mode the indoor unit will take 1 ~ 5
minutes to admit air (the actual delay time depends on the internal ambient temperature).
Set the temperature range by remote control: 16 ~ 30
℃
(61-86 ° F);
In automatic mode, the temperature can be displayed;
In automatic mode, it is also possible to adjust the set temperature. This mode indicator is not available for some models.
