5
TEMPERATURE SENSOR SELECTOR (A/C SENSOR)
●
Under normal conditions the room temperature is detected and
checked by the temperature sensor placed in the remote control
unit.
●
This button activates the temperature sensor placed in the
indoor unit. Press this button
using a thin object, e.g. the point
of a pencil or a pen. The display
will show the mark. The
air conditioner will be set
according to the intake air
temperature of the unit (mean
temperature of room air).
For normal use it is recommended the temperature sensor in
the remote control unit to be activated.
The remote control unit sends the
temperature signal to the air
conditioner regularly at three
minute intervals. If the signal from
the remote control unit stops for
more than ten minutes due to
some troubles, the air conditioner
will switch to the temperature
sensor which is built into the indoor unit and controls the
room temperature. In these cases, the temperature around the
remote control unit may differ from the temperature detected
in the air conditioner position.
REMOTE CONTROL UNIT LOCATION
The remote control unit may
operate either from a non-fixed
position or from a wall-mounted
position. To ensure that the air
conditioner operates correctly, DO
NOT install the remote control unit
in the following places:
●
In direct sunlight.
●
Behind a curtain or other places
where it is covered.
●
More than 8 m. away from the air
conditioner.
●
In the path of the air conditioner
airstream.
●
Where it may become extremely
hot or cold.
●
Where it may be subject to electrical or magnetic noise.
●
Where there is an obstacle between the remote control unit
and the air conditioner (a check signal is sent from remote
control unit every 3 minutes).
1. Non-fixed position (1)
• Momentarily place the remote control unit in the desired
mounting position.
• Verify that the remote control unit can operate from this
position.
• Hang the remote control unit on the mounting screw tightened
into the wall.
NOTE
MODE
FLAP
FAN SPEED
SELECT
OFF
E
ON
HH
MM
TIME SET
SETBACK
NIGHT
ACL
CLOCK
TIMER
SELECT
A/C
SENSOR
REMOTE CONTROL UNIT
DISPLAY
WALL
WALL
(2)
(1)
THE SCREWS NECESSARY FOR THE
TWO DIFFERENT INSTALLATIONS ARE
SUPPLIED WITH THE INDOOR UNIT.
2. Wall-mounted fixed position (2)
• See non-fixed position (1).
• Remove the batteries from the remote control unit and tighten
the screw into the wall, then hang the remote control unit.
• Locate the pretrimmed hole in the battery compartment.
• Through the pretrimmed hole fix the remote control unit at
the wall using the supplied screw.
• Insert the two batteries, check that the remote control unit
operates correctly.
CAUTION
OPERATION WITH THE REMOTE CONTROL UNIT
Check that circuit breaker on the power panel is turned ON and
the operation selector of the indoor unit is in the ON position.
HOW TO USE THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit trasmitter
head directly at the air conditioner receiver.
(INDOOR UNIT)
RECEIVER
(TRANSMITTER HEAD)
REMOTE CONTROL
UNIT
EG