Argo Service Manual Ducting & Exhaust
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
DE-7
DE-19
DE-20
7.
Re-fasten the exhaust manifold to the engine. Torque to specification.
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT
ANT
ANT
ANT
ANT
Exhaust manifold gaskets should be replaced with new ones
8.
Assemble the muffler assembly to the exhaust manifold. The original compression
springs may be reused but new hardware is recommended.
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT
T
T
T
TANT
ANT
ANT
ANT
ANT
When tightening down the hardware between muffler and exhaust manifold, it is
critical not to overtighten the hardware. By no means should the compression spring
become coil bound. Tighten only enough to provide a good seal between muffler and
manifold. Over tightening can cause undue stress at the muffler inlet due to the
twisting and turning of the vehicle under application. Correct tension at the
compression spring allows for movement in this area.
9.
Reinstall the manifold heat shield and lower cover. Use the appropriate hardware as
illustrated in your parts manual.
10. Fasten the muffler and shroud assembly to the lower body at the front wheel well.
The lower rubber mounted support is slotted to provide adjustment for the tailpipe at
the exhaust screen hole. Ensure that the tailpipe does not touch any of the surround-
ing screen area and secure the assembly to the lower body.
Removing the Muffler (Conquest Models)
On Conquest vehicles manufactured from C19686, all 6x6 Conquests and
all 35th anniversary vehicles:
1.
Remove the 4 fasteners securing the heat shield over the muffler. Photo DE-21