Argo Service Manual Engine System
Ontario Drive & Gear Limited. www.odg.com
PH. (519)- 662-2840 FAX (519)- 662-2421
EN-7
There is limited space between the engine and power pack frame. Cut down an empty
plastic container to the correct height so it will fit under the engine oil drain. Make sure
the container will hold the amount of oil in the engine.
A ziploc plastic bag makes a convenient oil container. It conforms to the space available
and can be closed securely when the oil is drained, then lifted neatly out of the engine
compartment.
4.
When all the oil has been drained from the engine, clean and replace the drain plug.
MAKE SURE it is properly tightened before refilling the engine.
5.
See Oil Filter Replacement Below.
PLEASE DISPOSE OF WASTE OIL PROPERLY TO CONSERVE OUR ENVI-
RONMENT.
Oil Filter Replacement
During the initial engine break-in period, change the oil filter (Part No. 126-95 for Briggs
& Stratton engines and Part No. 127-68 for Kawasaki engines) when the oil is changed.
After that, change the oil filter every 50 hours.
Before installing the new filter, lubricate the rubber filter gasket with fresh engine oil.
Screw the filter on by hand until the gasket contacts the filter adapter. Tighten 1/2 to 3/4
turn more. Add the specified oil. See previous page for oil capacities based on the engine
powering your vehicle. Start and run engine to check for oil leaks. Stop engine and re-
check oil level. Add oil if required.
