Subject to change · TSE3-D_9193_1en_09/2019
More information at www.argo-hytos.com
Strana 6
8.2.2 Explanation of the menu level 2
rES
Restore factory setting.
ou1
Output function for OUT1:
• Switching signal for the pressure limit values: hysteresis function [H ..] or
window function [F ..], either normally open [. no] or normally closed [. nc].
ou2
Output function for OUT2:
• Switching signal for the pressure limit values: hysteresis function [H ..] or
window function [F ..], either normally open [. no] or normally closed [. nc].
• Analogue signal for the current system pressure: 4 ... 20 mA [I] or 0 ... 10 V [U].
dS1 / dS2
Switching delay for OUT1 / OUT2.
dr1 / dr2
Switch-off delay for OUT1 / OUT2.
uni
Standard unit of measurement for system pressure (display):
[bAr] / [mbar] / [MPA] / [kPA] / [PSI] / [inHG] / [iH2O] / [mmWS] .
P-n
Output logic: pnp / npn.
Lo
Minimum value memory for system pressure.
Hi
Maximum value memory for system pressure.
dAP
Damping of the switch point.
dAA
Damping of the analogue output.
Prerequisite: OUT2 setting is [I] or [U].
coF
Zero-point calibration.
coLr
Assignment of the display colours „red“ and „green“ within the measuring range.
cFH / cFL
Upper / lower value for colour change. Parameter only active after selection of
a freely definable colour window in the coLr parameter: [r-cF] or [G-cF].
diS
Update rate and orientation of the display.
9 Parameter setting
During parameter setting the unit remains in the operating mode. It continues to monitor with the existing parameters until the parameter setting
has been completed.
9.1 Parameter setting in general
3 steps must be taken for each parameter setting:
1
Select parameter
►
Press [
●
] to get to the menu.
►
Press [
▲
] or [
▼
] until the requested
parameter is displayed.
2
Set parameter value
►
Press [
●
] to edit the selected parameter.
►
Press [
▲
] or [
▼
] for min. 1 s.
> After 1 s: setting value is changed:
incrementally by pressing the button once
or continuously by keeping the button pressed.
Numerical values are incremented continuously with [
▲
] or decremented with [
▼
].
3
Acknowledge parameter value
►
Briefly press [
●
].
> The parameter is displayed again.
The new setting value is saved.
Set other parameters
►
[
▲
] Press [
▲
] or [
▼
] until the requested parameter is displayed.
Finish parameter setting
►
Press [
▲
] or [
▼
] several times until the current measured value is displayed or wait for 30 s.
> The unit returns to the process value display.
If [C.Loc] is displayed when an attempt is made to modify a parameter value, a parameter setting process is active via the IO-Link
communication (temporary locking).
If [S.Loc] is displayed, the sensor is permanently locked via software.
This locking can only be removed with a parameter setting software.
