2
The device complies with CE requirements
Read the safety instructions and operating instructions prior to
commissioning!
Note:
Illustrations do not always precisely correspond to the original. No legal claim can be derived
due to incorrect information. Product design is subject to change without notice.
1. Quick Start
The steps that must be executed for commissioning the
LubMon Connect
gateway are described
below. The following components are necessary for this:
1. Gateway
LubMon Connect
2. Connection of compatible sensors:
LubCos H2Oplus II,
LubCos Level,
LubCos Vis+
OPCom II
Analogue sensors using analogue/CAN nodes
μCAN.6.ai-SNAP
3. Sensor cable (order number: SCSO 100-5020)
4. Power supply including rubber connector (order number: SCSO 100-5080)
5. Configuration software for
LubMon Connect
(www.argo-hytos.com)
6. Additionally for longer cabling: CAN standard cable (5-pole, M12), CAN-T pieces (5-pole,
M12), CAN terminating resistors (5-pole, M12)
The configuration software for
LubMon Connect
can be downloaded from the website
www.argo-
hytos.com
.
The components must be prepared as follows:
A) Software installation
1. Installation is not required. The individual components of the software package are
executable immediately after the .zip file is unpacked.
