arf YAK55M 60CC, Instruction Manual, Page: 40 / 53

7. The new KUZA Fuel Tank with aluminum tank cap is preassembled. Complete the installation in the
fuselage using zip ties or velcro straps to hold the tank in position. Connect a fuel line between the tank
and carb, a fuel line between the tank vent and the bottom of the fuselage, and a fill line to a fueling port
which can be mounted on the fuselage side opposite your ignition switch. Make sure your vent line does
not come close to any hot exhaust part such as the muffler or canister. recommends the use of small zip ties
or fuel line clamps to secure the lines to the tank.
A barb on the bottom of the fuselage can be fitted for the vent.
8. The YAK comes with canister pipe tunnel. Standard muffler, pitts muffler, canister or tuned pipe can be
fitted. If a tuned pipe is going to be used the end of the can tunnel can be removed. The tunnel can be
closed off to accept canisters of all sizes, or stock mufflers. Follow the manufacturer’s instructions for
your exhaust system paying attention to vibration mounts if required and air flow requirements. Trial fit
your exhaust system now and work out any additional supports, but do not permanently install the system
until you fit the cowling in the next steps.
Pitts Muffler