arf EXTRA300L, Instruction Manual, Page: 22 / 37

2
．
The EXTRA is supplied with a high quality set of pull-pull cables and ball-links.
3
．
Locate the pull-pull cable set, threaded couplers, brass swaging tubes, and
ball-links. If the cable is one long piece, cut it into two equal length pieces. Thread
one end of the one cable through a brass tube and then through one of the threaded
couplers. Run the cable back through the brass tube and then loop it back through a
second time. Using a set of crimping pliers, place three crimps just tight enough not
to cut the brass tube but enough to securely hold the wire in place. Cut off the
excess cable with wire cutters. Wick thin CA into the brass tube to help hold the
cable secure. Repeat for the other cable.
4
．
Thread the couplers about half way into the ball links of the rudder. Hint:
remove the ball links from the rudder horn first to make this step easier and then
re-install once the couplers are threaded on. Feed the loose end of each cable into
the cable slots at the rear of the fuselage and feed them forward towards the servo