arf AT.6-TEXAN, Instruction Manual Book

Page: 31 / 36

AT.6-TEXAN -
ITEM CODE: BH75
INSTRUCTION MANUAL
31
1. Set the tail wheel assembly in place
on the plywood plate. The pivot point of the
tail wheel wire should be even with the rud-
der hinge line and the tail wheel bracket should
be centered on the plywood plate.
2. Using a pen, mark the locations of the
two mounting screws. Remove the tail wheel
bracket and drill 1mm pilot holes at the loca-
tions marked.
Elevator servo
Rudder servo
Throttle servo
C/A glue
3mm x 12mm
MOUNTING THE TAIL WHEEL
BRACKET.
3. Secure the tail wheel bracket in place
using three 3mm x 12mm wood screws. Be
careful not to overtighten the screws.
Mark point
Secure