AT.6-TEXAN
-
ITEM CODE: BH75
.
Instruction Manual
18
Locate the long piece of wire used for the
throttle pushrod. One end of the wire has been
pre-bend in to a “Z” bend at the factory. This
“Z” bend should be inserted into the throttle
arm of the engine when the engine is fitted onto
the engine mount. Fit the engine to the engine
mount using the screws provided.
Right side
130mm.
Mark point
INSTALLING THE ENGINE.
Pushrod wire.
Drill a hole 4mm
diameter
Summary of Contents for AT.6-TEXAN
Page 10: ...AT 6 TEXAN ITEM CODE BH75 Instruction Manual 10 3 x 15mm Mark point Secure Secure Secure ...
Page 12: ...AT 6 TEXAN ITEM CODE BH75 Instruction Manual 12 ...
Page 29: ...AT 6 TEXAN ITEM CODE BH75 INSTRUCTION MANUAL 29 Aileron control horn Remove covering ...
Page 34: ...AT 6 TEXAN ITEM CODE BH75 Instruction Manual 34 C A glue C A glue C A glue Cut ...
