Arf Pets Bark Collar, User Manual

Page: 11 / 26

P Prepare the Receiver Collar
To Insert and Remove the Batteries
2. Place the Collar in the right place and
3. Use the Test Light and install
Replacement batteries ( ) can be found at many retailers. 1.5-volt, LR03 AAA
Risk of explosion if battery is replaced by an incorrect type. Do not short circuit, mix
old and new batteries, dispose of in fire, or expose to water. When batteries are stored
or disposed, they must be protected from shorting. Dispose of used batteries properly.
1. Press and hold the On/Off Button until the Green LED light comes on.
(This takes approximately one second.)
2. Release the On/Off Button.
In normal mode, the Green LED will flash once every 5 seconds, indicating the Receiver
2. Release the On/Off Button. Note: To extend the life of the batteries, turn the Receiver Collar
off when it is not in use.
Step
2
1. Remove the Battery Cover and install
two (2), 1.5-volt (LR03 AAA) batteries with
correct positive (+) negative (-) sides.
And replace the Battery Cover
to the Receiver Collar. ( )
2A
cover the Securing Pads.( ) 2B
the Contact Points ( ). 2C
DO NOT OVER-TIGHTEN THE CONTACT
POINTS WHEN USING THE TEST LIGHT.
To turn Receiver Collar On
To turn Receiver Collar Off
1. Press and hold the On/Off Button
until the Red LED light shuts off.
(This takes approximately three seconds.)
Collar is on and ready to receive a signal from the Handheld Transmitter.
11
2A
22B B
22C C
Important: If the Receiver Collar is left on continuously, the maximum battery life will be around
three weeks.