Areva MiCOM P441, Technical Manual

Page: 273 / 636

Application Notes P44x/EN AP/E33
MiCOM P441/P442 & P444 Page 99/220
3. OTHER PROTECTION CONSIDERATIONS-SETTINGS EXAMPLE
3.1 Distance Protection Setting Example
3.1.1 Objective
To protect the 100Km double circuit line between Green Valley and Blue River substations
using relay protection in the POP Z2 Permissive Overreach mode and to set the relay at
Green Valley substation, shown in Figure 61.
Tiger Bay
System Data
Green Valley - Blue River transmission line
System voltage 230kv
System grounding solid
CT ratio 1200/5
VT ratio 230000/115
Line length 100km
Line impedance
Z1 = 0.089 + J0.476 OHM/km
Z0 = 0.426 + J1.576 OHM/km
Faults levels
Green Valley substation busbars maximum 5000MVA, minimum 2000MVA
Blue River substation busbars maximum 3000MVA, minimum 1000MVA
80 Km
Green valley
P3074ENa
100 Km
Blue River
Rocky bay
60 Km
21
21
FIGURE 61 - SYSTEM ASSUMED FOR WORKED EXAMPLE
3.1.2 System Data
Line length: 100Km
Line impedances: Z
1
= 0.089 + j0.476 = 0.484 / 79.4
° Ω
/km
Z
0
= 0.426 + j1.576 = 1.632 / 74.8
° Ω
/km
Z
0
/Z1 = 3.372 / -4.6
°
CT ratio: 1 200 / 5
VT ratio: 230 000 / 115
3.1.3 Relay Settings
It is assumed that Zone 1 Extension is not used and that only three forward zones are
required. Settings on the relay can be performed in primary or secondary quantities and
impedances can be expressed as either polar or rectangular quantities (menu selectable).
For the purposes of this example, secondary quantities are used.
3.1.4 Line Impedance
Ratio of secondary to primary impedance =
1200 / 5
230000 / 115
= 0.12
Line impedance secondary = ratio CT/VT x line impedance primary.
Line Impedance = 100 x 0.484 / 79.4
°
(primary) x 0.12
= 5.81 / 79.4
° Ω
secondary.
Relay Line Angle settings -90
°
to 90
°
in 1
°
steps. Therefore, select Line Angle = 80
°
for
convenience.
Therefore set Line Impedance and Line Angle: = 5.81 / 80
° Ω
secondary.