16
Transmitter Pairing
In the unlikely event that your Alara’s radio does not operate straight out of
the box (i.e. the transmitter is not paired with the receiver), use this guide
to rectify the problem. Once a receiver has been paired to the transmitter, it
should not be necessary to complete this procedure again as the ID code is
stored in the receiver.
1. If already fitted, REMOVE THE ALARA’S PROPELLER. Place the transmitter
and receiver within 1m of each other. Hold down the the transmitter’s
PAIR button, then switch ON the transmitter. The red LED (power)
indicator will light solid whilst the green LED will flash slowly.
2. Power the receiver ON noting that the LED will initially flash red / blue,
then change to fast flashing red. For initial pairing the receiver must be
powered on within 5 seconds of the transmitter. Once paired this time
constraint is no longer necessary.
3. Pairing will be complete when the receiver’s fast-flashing red LED turns
solid red. You should now have full control of your Alara. Reboot the
system by switching the receiver OFF then the transmitter, and switching
back on again, transmitter first.
4. Refit the Alara’s propeller.
Summary of Contents for Alara
Page 1: ...Owner s Manual Technical Information RTF...
Page 19: ...19...
Page 20: ...www Ares RC com REV 003...
