2/4
ING0012
TRANSPORT AND SHIPPING
Open the shipping carton and verify that all equip
ment necessary to operate the system has arrived
intact. Refer to the following packing list for
information on what items are included with your
model. If any equipment is missing or damaged,
contact your Arena Luci dealer immediately.
No. 1 LED inground ING0012
No. 1 Recessed box
Before beginning initial setup of your LED
inground, make sure that there is no evident da
mage caused by transportation. In the event that
the unit’s housing is damaged, do not plug it in
and do not attempt to use it until after contacting
your Arena Luci dealer for assistance.
INSTALLING THE DEVICE
Before carrying out any operation, disconnect the
mains voltage from the system.
Slide the LED head out of the recessed box.
The installation can be performed via the included
dedicated inground/recessed box. It must be
positioned so that when the installation is
complete, the unit is at the same level of ground
surface or floor: that is, the upper side of recessed
box should match the finished surface.
A
the inground box must be placed on a layer of
draining pebbles with a minimum thickness of
30cm in order to make easier the flow of rain
water and avoid the lift of moisture inside the box.
At the end of the installation it will be possible to
manually orient the LED head to direct the light
beams where desired.
B
the bottom layer of the installation should be ma
de with a material with proper draining capability.
C
the shunt from the 230 V AC line should be
performed using an IP68 rated cast resin joint.
D
the connection between the 230 V AC line and
the supply cable of the luminaire should be
performed through the recessed box, using an
IP68 rated power connection. Keep enough cable
length for maintenance purposes.
Complete the installation by closing the LED head on
top of the recessed box, pushing until the LED head
is fully inserted.
The fixture can be used either for indoor or
outdoor installations, thanks to the die cast alumi
