5/8
USER’S MANUAL
8. Factory Reset a Lighting Device (Touch Reset)
Note
: the device shall be added to a network, the remote added to the same one or not added to any network
.
ZigBee Lighting Device
< 10cm
Step 1
: Set the zigbee device to start
TouchLink commissioning, refer to its
manual
.
LED indicator
Step 2
: Bring the remote within 10cm of
the lighting device
.
Step 3
: Press and hold down until LED
indicator turns on
.
Step 4
:Immediately short press 5 times to
start Touch Reset of the remote
.
LED
indicator flashes fast for 3S, then flash 3
times slowly to indicate successful reset.
S1
S2
S3
7. Remove from a Zigbee Network through Coordinator or Hub Interface
From your ZigBee controller or hub
interface, choose to delete or reset
the remote as instructed, indicator
flashes 3 times quickly to indicate
successful removing.
6. Zigbee Network Pairing through Coordinator or Hub
(
Added to
a
Zigbee Network
)
LED indicator
Note: 1) After pairing successfully, the remote information will appear on the controller or hub interface.
2) No remote information will appear on the hub interface if pairing to Philips Hue Bridge.
Step 1:
Remove the remote from
previous zigbee network if it has already
been added to it, otherwise pairing will
fail. Please refer to the part "Factory
Reset Manually".
Step 2:
From your zigbee controller or
hub interface, choose to add device or
accessory and enter Pairing mode as
instructed by the controller.
Step 3:
Press and hold down until LED
indicator turns on.
Step 4:
Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network. Indicator
will then blink 5 times quickly for
successful pairing.
S1
S2
S3