4/8
LC5003
press displays red again, and so on. Also in this
case the control unit keeps track of which cell is
playing, so that if you launch the automatic
sequence or if you change the colour with the
colour wheel, each new press on memory pad will
reproduce the proper colour of the next cell.
It is possible to replace the colours in the three
memory cells, so as to quickly recall the three
colours that you most frequently use. Repeatedly
press the pad memory until you see the colour
that should be replaced; set the new colour with
one of the previously seen modes (single colour
RGBW, or colour wheel, or by automatic
sequence, but it must be paused before storage),
and then press and hold the memory pad for more
than 5 seconds; the connected lights will flash
once to indicate the correct storage of colour.
Repeat the same steps to change the colour of
the other two memory locations.
INSTALLATION AND CONNECTION
Before carrying out any operation, disconnect the
unit from any power supply.
Remove the front panel from the body of the unit,
using a screwdriver in the reference notch at the
bottom; this is essential to be able to fix the unit.
Be careful not to damage the electrical contacts of
the central connector that joins the body to the
front panel of the controller.
The LC5003 controller must be installed in a
standard flush box type 503. Lay the box in the
desired position, practicing the track into the wall
needed to house the box and corrugated pipes
that carry either the electrical power line, the
control lines to LED luminaires and the DMX
control line to the lighting system.
It is also possible to mount on the wall, in this
case the connection cables can reach the control
unit through a duct wall.
Respect the polarity of the anode-cathode LED
devices. Connect to the "+" terminal the positive
supply line of LED devices, connected to "R", "G",
"B" terminals the negative power lines of the of
RGB LED devices, connected to "W" terminal the
negative power line of white-light LED devices.
The terminal block can accept conductors of cross
section between 0.5 and 1 .5 mm
2
; for fixing
remove approximately 6-7 mm of insulation from
the wires.
The choice of power supply for the interface must
be carried out according to the total power
absorption of all LED equipments connected; once
you have this value, you can choose among the
wide range of power supplies that Arena Luci
provides.
It is recommended to leave a margin of at least
the 25% less than the driving capability of the
supply unit.