Arena Luci AR3333--RGBWA, User Manual

Page: 4 / 12

4/12
AR3333­RGBWA
The projector can also be placed on one flat
surface. Loosen the side knob and open the two
forks to guarantee a stable support. Adjust the
inclination of the projector and finally tighten the
knob firmly.
POWER SUPPLY ­ MAINS
Disconnect the mains voltage from the system.
Pay attention to the voltage and frequency
indicated on the label.
An adapter for the power cable with schuko
socket is included in the package, if standard wall
or panel sockets are available.
The power cord coming into the projector is
equipped with a male­type waterproof joint; for the
connection to the electricity grid screw the
corresponding waterproof female coupling of the
schuko adapter. In the case of a single
installation, the lines of the POWER OUTPUT
extension cable must be properly insulated to
prevent accidental contact.
If your installation foresees the power supply of
the devices with flying cables, it is necessary to
remove the watertight joint from the input cable of
the projector and prepare the connection by
means of suitable male/female connection joints
(not included); in the case of outdoor installation,
the pairs of joints must have the most suitable
degree of protection for the environment.
Connect the power cord lines to the joint
terminals, respect the indicated L­N­E polarity
(color brown = L, blue = N, yellow / green = E).
It is essential that each projector is correctly
earthed and that electrical installation conforms to
all the standards of good practice and safety
regulations.
Whatever solution is chosen, screw firmly the two
joints to guarantee the impermeability of the
connection.
The projector does not have built­in on/off switch
and turns on immediately when power is supplied.
It is recommended that the projector is connected
to the mains via a proper switch, so that it can be
turned on and off individually.
The projector is equipped with a second output
power cable, to extend the power supply line
starting from the projector itself as needed: fix the
connection joints on the POWER INPUT and
POWER OUTPUT electric cables and simply
connect the output connector to the input
connector of the next projector.
When extending the power supply line in this
mode, the maximum number of units that can be
connected in the chain is 15 using a 1.5mm
2 cross
section cable.