Area Imager IG610/BT, Configuration Manual

Page: 147 / 196

138
Chapter 8 Miscellaneous Scanner Options
Introduction
This chapter includes commonly used bar codes to customize how data is
transmitted to the host device.
See Appendix A, Standard Default Parameters for all host device and
miscellaneous scanner defaults. If the default values suit requirements,
programming is not necessary.
There are two ways to change a parameter value:
y
Scan the appropriate bar codes in this guide. These new values
replace the standard default values in memory.
y For SSI and USB SNAPI hosts, send a “parameter send” command
from the host system. Hexadecimal parameter numbers are shown
in this chapter below the parameter title, and options are shown in
parenthesis beneath the accompanying bar codes.
Note: Most computer monitors allow scanning the bar codes directly on the
screen. When scanning from the screen, is sure to set the document
magnification to a level where the bar code can be seen clearly, and bars
and/or spaces are not merging.
To return all features to default values, scan the Set Default Parameter bar
code. Throughout the programming bar code menus, default values are
framed.
Scanning Sequence Examples
In most cases, scan one bar code to set a specific parameter value. Other
parameters, such as Prefix Value, require scanning several bar codes. See
each parameter for descriptions of this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence,
just re-scan the correct parameter.