Tube holder sockets
Parts List:
J8 - J13
2 x 6 2.54mm Female headers
We suggest you put the sockets on the board, but you can also reverse the connectors and put
the header pins on the board if you prefer. We prefer to put the sockets on the board, because
this means that no high voltages are exposed when the tube is unplugged.
If you decide to put the header pins on the board, please invert the components referred to in
this section and the section about the tube holders.
Place the 6 sockets in the marked locations and solder them.
At the end of this step, your board should look like this:
Warning!
Do not start mounting the LEDs until you have mounted the tube
holder boards.
You will need to determine the correct height of the LED using your completed
tube holders.
If you want to watch a video of this build step, please see the associated
video at:
https://www.bitchute.com/video/EGtqhpK7pO22/
9
Tube Sockets
