Ardo VDR06, Manual

Page: 15 / 132

15
SM2255
INSTALLING THE APPLIANCE
GB
USING THE DRIER
USING THE APPLIANCE
10
11
ELECTRICAL CONNECTION
9
8
▼
Make sure that the voltage indicated on the identifi cation plate attached to the
back of the appliance corresponds to that of the mains supply.
▼
On completion of the installation, the appliance must be connected to the mains
supply through a two-pole switch.
▼
All cutouts, electric wiring and mains sockets must have a rating such that enables
them to support the maximum load indicated on the identifi cation plate.
▼
The mains supply to which the appliance is connected must be fi tted with an
earthing system. If this is not the case, the manufacturer will not be held liable
for any incidents that may occur (fi g. 8).
▼
If the power supply cable is damaged in any way, contact the nearest customer
service centre.
▼
The drier must not be connected to the mains supply using indirect methods
such as extension leads or multiple adapters.
▼
Position the appliance so that the power supply cable is easily accessible for
disconnection when the need arises.
Important: On completion of the drying cycle, disconnect the appliance from the mains supply
to prevent young children from operating the drier.
3. Programmer knob Used to select the required programmes according to the
types of fabrics and their specifi c needs. If, for any reason, you want to change
the program or add more washing to the load during the drying cycle, simply
place the programmer knob in the “STOP” position. Then re-position the knob
on the required program and press the “START” button (fi g. 9).
NB. Warning!! Only use this function if strictly necessary and then only if
the program to reset has been running for less than 3 minutes.
1. Start button Press this button to start the programmed drying cycle (fi g. 10).
2. Start LED Off indicates the “STOP” position. On fi xed indicates the cycle is run-
ning. Fast fl ashing indicates the set programme is ready to start. Slow fl ashing
indicates the end of the drying programme (fi g. 11).