Ardo VDR06, Manual

Page: 14 / 132

14
SM2255
INSTALLING THE APPLIANCE
INSTALLATION
GB
▼
Never cover the air intake on the back of the appliance.
▼
Place the fi lter in its normal position as shown (fi g. 4).
▼
Clean the inside of the drum using a damp cloth to remove any dust deposits.
6
Connect the exhaust tube to the outlet on the back of the drier (fi g.6), as follows:
▼
Connect one end of the tube to the connecting piece supplied.
▼
Rotate the connecting piece (together with the tube) anticlockwise in the drier
outlet.
▼
Feed the tube away from the back of the drier to the left or right through the
recess at the bottom of the drier body.
▼
Position the other end of the tube near a window or a ventilation aperture on an
external wall. If this is not possible, make sure that the room is well ventilated
when the drier is being used. Use the support supplied to anchor the tube (fi g.
7).
Adjustable feet. Place the drier upright so that it rests fi rmly on all four feet. Level
the drier by adjusting the feet as follows:
▼
Lift the drier slightly.
▼
Adjust the feet to the correct height (fi g. 5). (Do not unscrew the feet too much
and do not use a screwdriver).
▼
Lower the drier.
A badly levelled machine may cause damage to the bearings and lead to their
premature wear. This drier does not need to be anchored to the fl oor.
LEVELLING THE DRIER
CONNECTING THE AIR EXHAUST TUBE
4
7
Important: The air exhaust tube must be connected even if the air is not discharged outdoors,
otherwise the drier will re-absorb the discharged damp air and thus prolong the drying time.
Damp air can also damage the drier. Although the air discharged from the exhaust tube is only
warm and damp and does not constitute a danger, it must never be directed towards people,
animals or plants.
Important: The exhaust air must not be conveyed to a chimney discharging fumes
generated by gas or other fuel burning appliances.
5