Ardo VD06S, Manual

Page: 15 / 124

15
SM1888
USING THE APPLIANCE
DESCRIPTION OF THE FUNCTIONS
10
11
INSTALLING THE APPLIANCE
GB
ELECTRICAL CONNECTION
9
8
▼
Make sure that the voltage indicated on the identification plate attached to the
back of the appliance corresponds to that of the mains supply.
▼
On completion of the installation, the appliance must be connected to the mains
supply through a two-pole switch.
▼
All cutouts, electric wiring and mains sockets must have a rating such that
enables them to support the maximum load indicated on the identification plate.
▼
The mains supply to which the appliance is connected must be fitted with an
earthing system. If this is not the case, the manufacturer will not be held liable
for any incidents that may occur (fig. 8).
▼
If the power supply cable is damaged in any way, contact the appropriate spe-
cialised customer technical service centre.
▼
The drier must not be connected to the mains supply using indirect methods
such as extension leads or multiple adapters.
▼
Position the appliance so that the power supply cable is easily accessible for
disconnection when the need arises.
Important: On completion of the drying cycle, disconnect the appliance from the mains sup-
ply to prevent young children from operating the drier.
▼
Drying time control knob: Rotate the knob to select the required drying times
(fig._9).
(Refer to the program table to select the program according to the type of fabric)
▼
At the end of each drying cycle, the appliance effects a 10 - 15 minute cooling
cycle, during which time the appliance is still switched on.
▼
Start button: Press this button to start the drying cycle (the indicator will light
up).
▼
Delicate or energetic drying button: This button is used to select the type of
drying cycle to run: Energetic or delicate (fig.11).
Energetic
Delicate