ARCTIC WIND 2AD22A, Owner'S Manual

Page: 14 / 20

13
REMOVING THE COLLECTED WATER
CONTINUED
Continuous draining
• Water can be automatically emptied into a floor drain by attaching a drain hose (ld≥Φ5/16′′, not
included) with a female threaded end (ID:M=1′′, not included) to the drain outlet at the back of
the dehumidifier (See Fig. 8)
• Remove the plastic cover from the continuous drain outlet at the back of the unit and set it aside.
• Connect the drain hose to the drain outlet of the unit and lead the drain hose to the floor drain or
a suitable drainage facility (See Fig. 9)
• Make sure the hose is secure and there are not leaks or kinks that will stop the water from
flowing.
• Make sure the hose is angled down or level to allow for good flow of water towards the outlet.
• Select the desired dehumidifier setting, humidity level and fan speed.
Pump draining (on some models)
• Water can be automatically emptied into a floor drain or a suitable drainage facility by connecting
the pump drain hose (ΦOD=1/4′′, supplied) with the pump drain outlet as shown in Fig. 12 and
using the pump feature on the dehumidifier.
• If a continuous drain hose is being used, remove it from the unit and reinstall the plastic cover to
the continuous drain outlet.
• Connect the supplied the pump drain hose onto the pump drain hose outlet (See Fig 12.)
• Make sure the hose is pushed on to the pump drain outlet to a depth of at least 1/2 inch (approx.
15 mm).
• Direct the drain hose outlet a floor drain or a suitable drainage facility.
• Press the PUMP button on the control panel to start the pump operation
• The pump will start when the bucket is full
2
3