40
9. High Beam Indicator - The High Beam icon will appear only
when the headlights are on high beam.
10. 4WD Lock Indicator - Displays LOCK when the front differential
lock has been engaged. Not utilized on this model.
11. Drive Select Indicator - Displays 4WD when selected by the drive
select switch or when the 4WD lock is engaged. The display is
blank when in 2WD.
12. Speedometer/Tachometer - Indicates the approximate vehicle speed in
miles per hour (MPH), kilometers per hour (KPH), or RPM.
Condition Warning Display - Uses odometer/trip meter display of the
LCD to warn of a system error condition requiring attention.
A. Volt - The LCD will go blank except the word VOLT will flash
on the LCD whenever a low voltage (<9 DC volts) or a high
voltage (>16 DC volts) is detected. When voltage returns to
normal, the gauge must be reset by turning the ignition key to
the OFF position and then to the ON position.
B. EFI - The LCD will go blank except a diagnostic trouble
code (DTC) code will flash on the LCD and a wrench icon
will be displayed whenever an electronic fuel injection mal-
function is detected. After 30 seconds, the LCD will return
to normal; however, the DTC and wrench icon will continue
to be displayed until the malfunction is corrected.
NOTE: Take the ATV to an authorized Arctic Cat ATV dealer
to have the EFI error corrected and to have the ECM reset as
soon as possible.
Oil Level Stick
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: The ATV should be on
level ground when checking the
engine oil level.
1. Unscrew the oil level stick and
wipe it with a clean cloth.
2. Install the oil level stick and thread it into the engine case.
3. Remove the oil level stick; the
engine oil level should be above
the “L” mark but not higher than
the “F” mark.
Seat Latch
1. To remove the seat, pull back on
the latch release (located under
the right rear of the seat); then
raise the rear of the seat and
slide it rearward.
CAUTION
Do not overfill the engine with
oil. Always make sure the oil
level is above the “L” mark but
not higher than the “F” mark.
KC0051A
ATV-0100AA
KC376A
