Arco Qld Pty Ltd/Manual
Page 4 of 7
Rotate drum in the up direction so that the bolts for fixing the curtain to are 9 o’clock
(looking from drive side). Remove the nuts and lift the curtain up by leaning over the drum
and fit the mini slats to the drum and replace the nuts and tighten.
Rotate the drum (Motor if power connected, hand chain or electric drill with bolt fitted to
rear of motor) in the open or up direction until the curtain is fully wound on with the bottom
rail just below the lintel (while winding curtain on, ensure that it stays straight), remove the
sling.
Tension the door by turning the capstan wheel from the top and away from the wall, 2
complete turns.
Install the guides (tracks) by sliding the track up and over the bottom rail and curtain. The
track should be approximately 10mm back from the opening and vertical. If tracks are fitted
to steel, they should be stitch welded (30-40mm) starting 200-300mm from top and a
maximum of 700mm between stiches. If tracks are fixed to concrete or bricks, the lugs
should be fitted to the track starting 250-300mm from the top and maximum spacing of
700mm.
STEP 3 : TESTING & SETTING THE LIMIT
Setting the limits on the controller.
Turn power supply on.
Press DOWN Button to check motor is going in the right direction. If not, refer to next step.
(To change direction of motor drive, press and hold STOP button then press SET button three
(3) times and SET button should start flashing, release ALL buttons. Press and hold STOP
button until SET button flashes quickly then release. Check Direction again by pressing
DOWN button. If correct, return to setting of limits).
Press and hold STOP button now and press the SET button three (3) times and the SET
button should be flashing.
Press the DOWN button and the door should travel down and take your finger off the down
button when the door touches the floor.
Press the SET button and should flash quickly, the bottom limit is set. When SET is flashing
normally, you can now set the open limit by pressing and holding the UP or OPEN button
until the door is in the required open position.
Press the SET button again and it should flash quickly and then flashing stop. If this happens,
the limits are set.
MAINTENANCE
Regularly clean the Curtain with cloth and water.
Avoid using chemicals to prevent from discoloration.
Regularly check for foreign materials build up on the guides.
NOTES:
For Orders, please use the lay-out sheet, input all the details.
* STADIUM ALUMINIUM ROLLER GRILLE, ARCADE 3 & Q100 STEEL ROLLER SHUTTER are generally behind Wall
Fixing.
