/
9
/
60
EN
3
INSTALLATION
Refer to the nearest Authorised
Service Agent for installation of your
product. To make the product ready
for use, make sure that the electricity,
tap water supply and water drainage
systems are appropriate before calling
the Authorised Service Agent. If they
are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations at
the place of installation is
the customer's responsibility.
B
Installation and electrical
connections must be carried
out by the Authorised
Service Agent. Manufacturer
shall not be held responsible
for damages arising from
processes carried out by
unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not
have it installed. Damaged
products cause risks for
your safety.
C
Make sure that the water
inlet and discharge hoses
are not folded, pinched or
crushed while pushing the
product into its place after
installation or cleaning
procedures.
When placing the product, pay
attention not to damage the floor, walls,
piping, etc. Do not hold the product by
its door or panel to move it.
Appropriate installation
location
•
Place the product on a solid and
flat floor that has sufficient load
carrying capacity! The product
must be installed on a flat surface
in order for the door to be closed
comfortably and securely.
•
Do not install the product at places
where temperature may fall below
0ºC.
•
Place the product at least 1 cm
away from the edges of other
furniture.
•
Place the product on a rigid floor.
Do not place it on a long pile rug
or similar surfaces.
B
Do not place the product on
the power cable.
•
Make sure that you select a
location that will allow you to load
and unload the dishes in a fast
and comfortable manner.
•
Install the product in a place close
to the tap and the drain hole.
Select the installation location
by considering that it will not be
changed after the connections are
made.
