9/36 EN
Refrigerator / User Guide
*OTUBMMBUJPO
3.1. Right place for installation
Contact the Authorized Service for the
product's installation. To ready the product
for installation, see the information in the
user guide and make sure the electric and
water utilities are as required. If not, call
an electrician and plumber to arrange the
utilities as necessary.
B
8"3/*/(
The manufacturer
assumes no responsibility for any
damage caused by the work carried
out by unauthorized persons.
B
8"3/*/(
The product’s power
cable must be unplugged during
installation. Failure to do so may result
in death or serious injuries!
A
8"3/*/(
If the door span is too
narrow for the product to pass,
remove the door and turn the product
sideways; if this does not work,
contact the authorized service.
t 6+-/>2/:<9.?->98+06+>=?<0+-/>9+@93.
vibration.
t 6+-/>2/:<9.?->+>6/+=>-7+A+C
from the heater, stove and similar sources
of heat and at least 5 cm away from
electric ovens.
t989>/B:9=/>2/:<9.?->>9.3</->
sunlight or keep in damp environments.
t $2/:<9.?-></;?3</=+./;?+>/+3<
circulation to function efficiently.
t )9?<:<9.?-></;?3</=+./;?+>/+3<
circulation to function efficiently. If
the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls.
t0>2/:<9.?->A366,/:6+-/.38+8+6-9@/N
remember to leave at least 5 cm clearance
between the product and the ceiling, rear
wall and the side walls. Check if the rear
wall clearance protection component is
present at its location (if provided with the
product). If the component is not available,
or if it is lost or fallen, position the product
so that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance at
the rear is important for efficient operation
of the product.
t 989>38=>+66>2/:<9.?->38/8@3<987/8>=
with temperatures below -5°C.
3.2. Attaching the plastic wedges
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
To attach the wedges, remove the screws on
the product and use the screws provided with
the wedges.
Attach 2 plastic wedges on the ventilation
cover as shown in the figure.
3.3. Adjusting the stands
If the product is not in balanced position,
adjust the front adjustable stands by
rotating right or left.