Service Support Spirit
29
Unique Solution
WWW.ARCBRO.COM
8.1.11 [Y] AU-SPD
Since the manual speed and automatic speed is separate in the system, this key is used to
switched between automatic mode and manual mode to adjust the speed multiplying factor.
8.2. Function selection in AUTO mode
It is allowed to invoke a machining program by means of
EDIT
feature. If a program has been invoked (as long
as it is the same program name), it can be run directly. If the program is invoked from an USB disk, especially a
large program, it can be run directly with USB disk connected instead of saving it into the system.
8.2. 1[F1] SECTION
To assign system to start up machining operation from any section or piercing point.
It is often used when machining needs to start from a certain section or only a part needs
being processed. Refer to
SECTION
feature for details.
8.2.2[F2] MAN
To switch the system to manual mode.
8.2.3[F3] RESBREK
After this function is selected, pressing [
START
] key to fulfil breakpoint restoration. Refer to
RESBREK
feature for details.
8.2.4[F4] VIEW
It is used to test the program for any error. When this feature is selected, the pattern of
machining program will be displayed with a cross cursor at the origin.
[S] key is used to magnify the pattern, one times by one keystroke and eight times maximum
by three keystrokes. [Q] key is used to return the pattern to original size. The display position
of pattern is moveable by pressing [↑], [↓], [←]
and/or [→] key.
8.2.5[F5] KERF
This key is used to reminder input of kerf compensating width; if no necessary to
compensate (usually in blanking), simply enter 0.