16
Issue date: 05/02/2020
Timer operation to
‘OFF’ position. (LED on module will flash twice)
1. Close magnetic sensor will trigger ON signal to receiver device and timer
will start to count down, once it reaches 0 minute the sensor will send
OFF signal to the receiver device.
2. During timer countdown if you separate magnetic sensor it will not turn
OFF the receiver device, the timer will still countdown until it reaches 0
minute then sends OFF signal to the receiver device.
3. Or during the timer countdown, if you close the magnetic sensor again
then this will extend the timer further more.
For example:
Function switch in position ‘OFF’ and timer set under 1 minute.
1. When you close the door the sensor triggers ON signal to the receiver
device and 1 minute timer starts to countdown.
2. During the countdown say around 30 seconds the door is opened again,
the sensor will trigger receiver again which means the timer will extend
another 1 minute on top of the remainder 30 seconds.
3. So after 1 minute and 30 seconds the receiver device will turn OFF.
DELAY OFF TIMER SETUP
