Speaker Installation
Road Glide
Speaker Installation
Step 6-
Installing the Speakers
A. Remove the (3) T25 torx screws that hold the factory
speaker plate in place. (See Figure 6A and 6B)
B. With both speaker panels removed from the motorcycle
remove the (4) #2 phillips screws from the speakers and
seperate. (See Figure 6C)
--If installing Coaxial Speakers skip ahead to step 6I--
C. Carefully remove the front grill screen attached to
the speaker plate. Be carefuly to not rip the material
as it is attached to the plastic plate with double sided
tape. (See Figure 6D)
D. Carefully position your hole saw in the far corner
of the now bare speaker plate. Then drill your tweeter
openings. (See Figure 6E)
E. Seperate the tweeter cup assembly from the tweeter
and mark the top trim of the cup for trimming. Once you
have marked the tweeter trim the edge of the lip of the
tweeter so that it can sit flat onto the plate. (See
Figure 6F) Trim the outer edges and then grind them
smooth with a grinder or sand paper. Then firmly press
them in place.(See Figure 6F)
F. After the upper tweeter trim rings have been trimmed
and cleaned using a hot glue gun, secure the tweeter
trim cup to the plate with a sufficient ammount of adhe-
sieve. (See Figure 6G)
G. After giving the tweeter cups suffecient time to
allow the hot glue to dry mount the tweeters to the cups
by pressing firmly till you hear the 2 parts of the cup
snap together.
Figure 6A-
Figure 6B-
Figure 6C-
Figure 6D-
Figure 6E-
Figure 6F-
Figure 6G-
