Arbor Technology AES-5204, User Manual

Page: 18 / 22

- 10 -
Installation & Maintenance
3.1. Disassemble the Computer
If you need to configure the power detection mode, you will need to disassemble the
computer to access the system power DIP switch. The following section will guide you to
disassemble the computer.
1. Power off your computer and unplug the power cord and any peripherals. Place the
computer on a flat surface. Loosen and remove the 4 screws on each of the side
panels and remove the side panels.
2. Loosen and remove the 2 screws on front and rear panels respectively.
3. Place the computer in an upright position. Grab the chassis edges as shown below
and apply gentle pressure outwards to disassemble the chassis.