6.6 Application Software – 1094B Utility
43
6.6.9
The Programmable Pulse B Screen
Select the Prog. Pulse B tab to configure how the 1094B sends pulses out Channel B. There are
four modes and seven pulse types from which to choose. Prog. Pulse B is identical to Prog. Pulse A
except that it includes two additional modes: (1) Frequency, and (2) IRIG-B. Channel B, IRIG-B
is independent from Channel A.
Figure 6.12: Programmable Pulse B Setup Screen
Modes:
(1) Off, (2) Pulse, (3) Frequency, and (4) IRIG-B.
Pulse Mode Types:
(1) Pulse per Second, (2) Pulse per Minute, (3) Pulse per Hour, (4) Pulse
per Day, (5) Single Trigger, (6) Slow Code, and (7) Seconds per Pulse.
Frequency:
Set frequency, from 1 to 1000, in pulses per second; no other settings are available.
Pulses have 50 percent duty cycle.
IRIG-B:
Select
IRIG-B
as Mode and go to IRIG-B tab, Channel B, to set up IRIG-B preferences.
Polarity, Alarm Time Mark, Pulse Width, and Pulse Delay:
See definitions on Pro-
grammable Pulse A in Section 6.6.8.