BASE RACK Beneath Installation.
Step 1.
Insert M6 Coach bolts into Mount bracket. Insert Mount bracket into BASE
RACK channel (Figure 5) and twist bracket into position (Figure 6). Complete
for opposite bracket.
Step 2.
Install Lightbar on Mount brackets. Use M8 Security bolts and M8 Double
washer to secure Lightbar onto Mount brackets. Keep bolts finger tight for
adjustment later. (Figure 7).
Step 3.
Ensure the Lightbar is central on the BASE RACK and install the Clamp
brackets onto the Mount brackets. Use M6 Washer and M6 Nyloc nut to
secure the Clamp bracket in place (Figure 8). Tighten nuts as per torque
specified in Table1.
Step 4.
For vertical adjustment, measure the light output height and compare with the
Lightbar height on the vehicle. The two measurements should be similar
depending on the user preference. Once satisfied with the adjustment, use
the security tool provided and tighten all four M8 Security bolts.
Pedestal Mount Installation.
Step 1.
Install Lightbar on Mount brackets. Use M8 Security bolts and M8 Double
washer to secure Lightbar onto Mount brackets. Keep bolts finger tight for
later adjustment. (Figure 9).
Step 2.
Position Lightbar with brackets onto mounting surface. Mark all four mounting
holes. Remove Lightbar and drill four mounting holes using 6.5mm drill bit
(not supplied). Use rust prevention on drilled holes.
Step 3.
Place Lightbar over mounting holes again and insert M6 Security bolts, M6
Washers and M6 Nyloc nuts. Tighten all nuts as per torque specified in
Table1. (Figure 10).
Step 4.
For vertical adjustment, measure the light output height and compare with the
Lightbar height on the vehicle. The two measurements should be similar
depending on the user preference. Once satisfied with the adjustment, use
the security tool provided and tighten all four M8 Security bolts.
FIGURE 5.
FIGURE 6.
FIGURE 7.
FIGURE 8.
FIGURE 9.
FIGURE 10.
